Marklin

This is a kit for converting C Track turnouts. It has a double solenoid mechanism with end shut-off contacts. It can be operated from a 72752 turnout control box with a feedback function or from a...

Locomotive in a racing paint scheme with lights. The Porsche models can drive on the ramp included with the set onto the two auto transport cars. All in One Set ? locomotive, freight cars, and all...

Quite a bit going on in the harbor. New freight reaches your loading station by the minute. Trucks drive directly into the hold of the freight ship using a ramp. The freight trains are unloaded using...

Prototype: German Federal Railroad (DB) 6-axle railroad rotary crane car with Ardelt system steam propulsion with a lifting capacity of 57 metric tons, with a crane tender car (converted from a type...

180 mm / 7-3/16". Contents: 6 pieces.

Completely new tooling. Factory-installed LED interior lighting. Different lighting scenarios for the interior lighting controlled digitally. Pantographs on the service car can be raised and lowered...

Prototypical turntable. Controller for the turntable, a Z locomotive controller, and a power supply included. This model is designed for recessed installation into a layout baseboard. It has 8 spoke...

Prototype: French State Railways (SNCF) TGV Euroduplex (train ? grande vitesse) high-speed train, in the version for service between Paris and Munich. 2 powered end cars (TK1 and TK2), 1 bi-level...

Prototype: German Federal Railroad (DB) class 218.4 diesel locomotive and 2 pairs of type WG3yge/WG3yge rebuild cars, 2nd class, with advertising for "Deutsche Weinstrasse". The train looks as it did...

Prototype: German Federal Railroad (DB) standard design block signal. 2 settings: "Stop" - red (Hp0) and "Proceed" - green (Hp1). Block signal for use on main lines. An appropriate distant signal by...

3 mm / 1/8" high. This base plate can be used only in conjunction with the 7250 base plate. Bridges and approach ramps bring the third dimension to a model railroad layout: from flatness to a sense...

2 aspects "Stop" (Hp0) and "Proceed" (Hp1). LED lighting. Height 34 mm / 1-5/16".

Reworked for Era IV. Car number 534 6 452-5. Two additional special felt pads included. Model: "Jorger System" track cleaning car. This freight car has a special spring-loaded holder on the underside...

Dealer package assortment with 10 rolls each of red, brown, blue and yellow wire. Length of each roll 10 meters / 390 inches. Wire cross section 0.75 sq. mm / 0.0012 sq. in. (approximately 18 gauge)...

2.5 mm / 3/32" high. This is used as a pillar foundation. Bridges and approach ramps bring the third dimension to a model railroad layout: from flatness to a sense of height. From the simple...

This is for converting Marklin locomotives with built-in AC/DC / field coil motors. The AC/DC marklin locomotive decoder supports the digital formats mfx, MM1, MM2, and DCC. It has particularly...

This set enables easy control of the turntable with track indexing in the Digital system. The deck turns to the right/left in single steps or continuously. The set consists of an electronic control...

Below-Baseboard Mechanism. Slow Motion Semaphore Movement. 2 aspects "Stop" (Hp0) and "Proceed" (Hp1). Single semaphore arm, with LED lighting, and below-baseboard mechanism permanently attached to...

For cars 4131, 4132 and 4133. The kit consists of a pickup shoe and a ground spring, an adjustable light diffuser, 2 light sockets and 2 light bulbs.

2 aspects "Stop, Movement Prohbited" (Sh0), "Movement Prohibition Lifted" (Sh1). LED lighting. Height 7 mm / 1/4".

2 aspects "Stop, Movement Prohibited" (Sh0), "Movement Prohibition Lifted" (Sh1). LED lighting. Height 7 mm / 1/4".

Finely crafted reproduction of important prototypes. Metal masts. LEDs for good illumination. Plug-in base for easy installation and removal. Height 56 mm / 2-7/32".

This is a replacement base for standard masts. It can be shortened for all available H0 track systems with or without roadbed. The base comes with a screw suitable for mounting a mast. 20 pieces to a...

Finely crafted reproduction of important prototypes. Metal masts. LEDs for good illumination. Plug-in base for easy installation and removal. Height 100 mm / 3-15/16".

This is a metal lattice mast and has two metal hanger arms. Both arms are electrically insulated. A base with a mounting screw and a slide-on connection is included. An additional base as a clip for...

This unit is a current inverter for the 66630/66361 and 60041/60061 switched mode power packs to change the voltage from DC to AC or for connections with accessories using DC voltage. The AC voltage...

The Connect-6021 is for bidirectional connections between the former Marklin Digital System and the 60213-60215 and 60216/60226 Central Station. This allows you to control 80 locomotives (Motorola...

4 aspects "Stop" (Hp0), "Proceed" (Hp1), "Proceed Slowly" (Hp2), and "Train Halt, Switching Allowed" (Hp00/Sh1). LED lighting. Height 34 mm / 1-5/16".

Robust, sturdy kit consisting of a few parts that snap together - ideally suited for children ages 3 and up. The stoplights with light and sound function provide maximum play enjoyment. The gates are...

Finely crafted reproduction of important prototypes. Metal masts. LEDs for good illumination. Plug-in base for easy installation and removal. Height 100 mm / 3-15/16".

This a metal lattice mast and has a metal hanger arm. A base with a slide-on connection is included. Additional mounting bracket for the Marklin bridge system. Height 100 mm / 3-15/16". 5 pieces to a...

Below-Baseboard Mechanism. Slow Motion Lens Movement. 2 aspects "Stop, Movement Prohibited" (Sh0), "Movement Prohibition Lifted" (Sh1). Movable lens, 1 light bulb, and below-baseboard mechanism...

For cars 42101, 42131, 4214, 42141, 42142 and 4229. The kit consists of a pickup shoe and a ground spring, a light diffuser, a light socket and a light bulb.

Connecting cable for direct connections between several 60213-60215 and 60216 and 60226 Central Stations and for connections to the 60125/60145 Terminal. Length approximately 2 meters / 79 inches.

Distribution device for connections for up to a maximum of 5 MS II to an output on the 60112 or 60113 digital connector box. An MS II Hub can be connected to both outputs on the connector box. Hence,...

3 aspects "Stop" (Hp0), "Proceed" (Hp1), and "Proceed Slowly" (Hp2). LED lighting. Height 34 mm / 1-5/16".

Below-Baseboard Mechanism. Slow Motion Semaphore Movement. 2 aspects "Stop" (Hp0) and "Proceed Slowly" (Hp2). 2 coupled semaphore arms, with LED lighting, and below-baseboard mechanism permanently...

1 left curved turnout with a manual hand lever. Inner curve: R1 = 360 mm / 14-3/16" / 30?. Outer curve: 30? with the parallel curve spacing of 77.5 mm / 3-1/16". Can be retrofitted with the 74492...

Length 1/1 = 30?.

Length 1/8 = 3? 45'.

R2 = 437.5 mm / 17-1/4" / 5.7? (extends turnouts to 30?).

Length 1/4 = 45 mm / 1-3/4".

Length 1/2 = 90 mm / 3-9/16".

Length 217.9 mm / 8-9/16".

Length 1/1 = 45?. Small radius for branch lines and industrial trackage. Cannot be used for long locomotives and cars.

R3 = 515 mm / 20-1/4" / 30?. Content: 3 pieces.

R1 = 360 mm / 14-3/16" / 30?.

360 mm / 14-3/16". Content: 2 pieces.

Length 1/2 = 15?. Radius 424.6 mm / 16-3/4". Momentary contact with a locomotive/car pickup shoe.

Length 1/2 = 15?. Radius 360 mm / 14-3/16". Momentary contact with locomotive/car pickup shoe.

Length 35.1 mm / 1-3/8".

1 right turnout with a manual hand lever. 188.3 mm / 7-13/32" / R2 = 437.5 mm / 17-1/4" / 24.3?. Can be retrofitted with the 74492 electric turnout mechanism.

Length 1/2 = 15?.

1 left turnout with a manual hand lever. 188.3 mm / 7-13/32" / R2 = 437.5 mm / 17-1/4" / 24.3?. Can be retrofitted with the 74492 electric turnout mechanism.

Length 1/4 = 7? 30'.

171.7 mm / 6-3/4".

Length 1/4 = 7? 30'.

Length 1/8 = 22.5 mm / 7/8".

R1 = 360 mm / 14-3/16" / 15?.

188.3 mm / 7-13/32".

Length 3/4 = 22? 30'.

Length 1/6 = 30 mm / 1-3/16".

Length 1/2 = 15?.

Length 1/1 = 180 mm / 7-3/32" (standard length).

94.2 mm / 3-11/16". Content: 1 piece. This is an uncoupler track for manual and electric uncoupling. The electric operation can be done only with the 72752 control box and the cable included with...

1 right curved turnout with a manual hand lever. Inner curve: R1 = 360 mm / 14-3/16" / 30?. Outer curve: 30? with the parallel curve spacing of 77.5 mm / 3-1/16". Can be retrofitted with the 74492...

Length 1/1 = 30?.

171.7 mm / 6-3/4". Content: 4 pieces.

Transparent C-Track curved R1, 30? for showcases, presentation bases and for decorative purposes. (Content: 6 tracks)

188.3 mm / 7-13/32". Content: 4 pieces.

R1 = 360 mm / 14-3/16" / 30?. Content: 3 pieces.

Track set consisting of 4 no. 24094 straight tracks (each 94.2 mm / 3-11/16" long) and 2 no. 24077 straight tracks (each 77.5 mm / 3-1/16" long).

Track set consisting of 4 no. 24224 curved track (turnout branch) and 2 no. 24206 curved track.

R2 = 437.5 mm / 17-1/4" / 30?. Content: 3 pieces.

This is for connecting a switched mode power pack 66360/66361 and up to 2 Mobile Stations (60657 and 60653). Dimensions 96 x 85 x 40 mm / 3-3/4" x 3-3/8" x 1-9/16".

R2 = 437.5 mm / 17-1/4" / 24.3? (turnout branch). Content: 1 piece.

Factory-installed LED interior lighting included. Operating, current-conducting close couplers. Interior lighting for the entire train consist can be controlled digitally from the decoder in the cab...

Completely new tooling. mfx digital decoder included. Headlights / marker lights can be controlled digitally. Long-distance headlights can be controlled digitally separately. Factory-installed LED...

360 mm / 14-3/16".

Radius 1,114.6 mm / 43-7/8". Curve 12.1?. Complementary curve for the wide radius turnouts and wide angle crossings. Also suitable for use in constructing sweeping main lines.

171.7 mm / 6-3/4". Package quantity: 6 pieces.

World of Operation mfx+ digital decoder and a variety of light and sound functions included. Model: The unit has an mfx+ digital decoder and extensive sound functions. It also has controlled...

Red marker lights / white headlights changeover. Model: The cab control car has a lighted destination board at the end. When operated control car first, triple headlights shine on the cab control...

77.5 mm + 5 mm / 3-1/16" + 1/16". Package quantity: 3 pieces

94.2 mm / 3-11/16".

Model: The sliding wall boxcars have separately applied steps. Length over the buffers 17.8 cm / 7". The sliding tarp car has a closed tarp and a hand wheel for setting brakes on the car from the...

Factory-installed LED interior lighting included. Operating, current-conducting close couplers. Interior lighting for the entire train consist can be controlled digitally from the decoder in the cab...

This is a set consisting of two track crossings that add many setup possibilities to the my world track assortment. The my world track sections are made of sturdy plastic just right for children.

103.3 mm / 4-1/16". 48.6?. For double crossovers or intersecting parallel routes.

Gauge: HO System: AC UPC/EAN: 4001883201993

R3 = 515 mm / 20-1/4" / 30?.

R3 = 515 mm / 20-1/4" / 15?. Removable roadbed slopes. This track section is required on both branches of the 24771 and 24772 wide radius curved turnouts.

Cars include different and new car numbers. Model: The boxcars have pitched roofs constructed of metal. There is one silver and two brown cars with inset ventilation grills. All of the cars have...

Factory-installed LED interior lighting included. Operating, current-conducting close couplers. Interior lighting for the entire train consist can be controlled digitally from the decoder in the cab...

Contents: 1 left turnout and 1 right turnout, as well as 2 sections of curved track to go with them (turnout curves), made of sturdy plastic just right for children.

77.5 mm / 3-1/16".

Length 70.8 mm / 2-13/16". Removable roadbed slope. This track is used on both branches of the wide radius turnouts and wide angle crossings.

Factory-installed LED interior lighting included. Operating, current-conducting close couplers. Interior lighting for the entire train consist can be controlled digitally from the decoder in the cab...

The ideal add-on for the Marklin my world Elevated Railroad from the "Airport Express - Elevated Railroad" starter set. Great play fun from playing in Levels 0 and 1. Building the Marklin my world...